56
2007 TUNDRA from Jul. ’07 Prod. (OM34463U)
NOTICE
To prevent damage to the seat, avoid
putting heavy loads on the temporary
table.
This system can memorize the position
of the driver’s seat, the tilt and tele-
scopic steering and outside rear view
mirrors, and recall them at the touch of
a button.
Buttons “1” and “2” can memorize two
separate positions.
XS13098a
SETTING THE DRIVING POSITION
The ignition switch must be in the “ON”
position and the selector lever is in the
“P” position.
1. Adjust the driver’s seat, tilt and
telescopic steering and outside rear
view mirrors to the desired position.
2. While pushing the “SET” button,
push button “1” or “2” until a beep
in heard.
The system can memorize up to 2 posi-
tions by repeating the above steps. If step
2 is performed when both buttons “1” and
“2” are memorized, the previous position
will be erased and a new position will be
set.
07 04.26
Driving position memory
system (on some models)
To Next Page
Loading...
Need help?
General
