239
2007 TUNDRA from Jul. ’07 Prod. (OM34463U)
XS17003b
Use the front drive control switch knob
to select the following transfer modes.
“2WD” (high speed position, two−wheel
drive): Front drive control switch knob at
“2WD”
Use this for normal driving on dry hard−
surfaced roads. This position gives greater
economy, quietest ride, least wear and
better vehicle control.
“4H” (high speed position, four−wheel
drive): Front drive control switch knob at
“4H”
The “4HI” (high speed four−wheel drive)
indicator light comes on when the “4H”
mode is selected.
Use this for greater traction than two−
wheel drive. (When you experience a loss
of power, such as wheel spinning.) This
position provides greater traction than
two−wheel drive.
In this mode, the vehicle stability control
system is off. (See “Vehicle stability
control system” on page 248 in this
Section.)
“4L” (low speed position, four−wheel
drive): Front drive control switch knob at
“4L”
The “4LO” (low speed four−wheel drive)
indicator light comes on when the “4L”
mode is selected.
Use this for maximum power and traction.
Use “4L” position for climbing or descend-
ing steep hills, off−road driving, and hard
pulling in sand, mud or deep snow.
See “(c) Shifting procedure” for further in-
structions.
In this mode, the vehicle stability control
system is off. (See “Vehicle stability
control system” on page 248 in this
Section.)
07 04.26
Four−wheel drive system
(a) Front drive control
To Next Page
Loading...
Need help?
General
