257
2007 TUNDRA from Jul. ’07 Prod. (OM34463U)
D When changing the tire inflation pres-
sure according to the instruction for
traveling speed, load weight or tire
size.
To initialize the system, perform the
following:
1. Park the vehicle in a safe place and
turn the ignition switch to the “ACC” or
“LOCK” position.
2. Adjust the pressure of all the installed
tires to the specified cold tire inflation
pressure level. (See “Tires” on page
586 in Section 8.)
3. Turn the ignition switch to the “ON”
position.
4. Push and hold the tire pressure warn-
ing reset switch until the tire pressure
warning light blinks slowly three times.
5. Wait for 7 minutes with the ignition
switch “ON”, and then turn the ignition
switch to the “ACC” or “LOCK” posi-
tion.
If you push the tire pressure warning re-
set switch while the vehicle is moving,
initialization is not performed.
If you push the tire pressure warning re-
set switch accidentally and initialization is
performed, adjust the tire inflation pres-
sure to the specified level and initialize
the system again.
XS17018b
Type A
XS17017b
Type B
07 04.26
To Next Page
Loading...
Need help?
General
