564
2007 TUNDRA from Jul. ’07 Prod. (OM34463U)
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
The side turn signal lights consist of a
number of LEDs. If any of the LEDs burn
out, take your vehicle to your Toyota deal-
er to have the light replaced.
CAUTION
D To prevent burning yourself, do not
replace the light bulbs while they
are hot.
D Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toyota dealer.
Light bulbs
Bulb
No.
W Type
Headlights
(high beam)
9005 65 A
Headlights
(low beam)
— 55 B
Front fog lights 9145 45 C
Parking and front
side marker lights
168 5 D
Front turn
signal/parking
lights
4157
NAK
27/8 E
Rear turn signal
lights
3157A 27/8 E
Stop/tail and rear
side marker lights
3157 27/8 D
Back−up lights 921 18 D
License plate
lights
168 4.9 D
High mounted
stoplight and
cargo lamps
921 18 D
Interior lights — 5 D
07 04.26
Replacing light bulbs—
To Next Page
Loading...
Need help?
General
