26
2007 TUNDRA from Jul. ’07 Prod. (OM34463U)
LS12018
2. Remove the circuit board, then remove
the discharged transmitter battery.
NOTICE
z Take care not to damage the circuit
board.
z Do not bend the terminals.
LS12019
3. Put in a new transmitter battery with
positive (+) side up. Install the circuit
board into the transmitter case.
Close the transmitter case securely.
NOTICE
z Make sure the positive side and
negative side of the transmitter bat-
tery are faced correctly.
z Do not replace the battery with wet
hands. Water may cause unexpected
rust.
z Do not touch or move any compo-
nents inside the transmitter, or it
may interfere with proper operation.
z Be careful not to bend the electrode
when inserting the transmitter bat-
tery and that dust or oils do not
adhere to the transmitter case.
z Close the transmitter case securely.
After replacing the battery, check that the
transmitter operates properly. If the trans-
mitter still does not operate properly, con-
tact your Toyota dealer.
07 04.26
To Next Page
Loading...
Need help?
General
