Conversion between Conventional and SI Units
Equations for conversion
Value in SI unit
=
Conversion rate
x
Value in conventional unit
Conversion rate: Figure corresponding to
X
in the
Value in conventional unit
=
Value in SI unit
+
Conversion rate
conversion rate column in the table
above
Caution:
When converting, change the unit of the value in conventional or SI units to the one in the conversion rate
column in the table above before calculation. For example, when converting
100
W to the value in
conventional unit PS, first change it to
0.1
kW and divide by the conversion rate
0.735499.
HANDLING FlPG (LIQUID GASKETS)
FIPG:
08826-7600 1-71
Example of Application Area
Points for application method and reassembling parts.
Caution:
When removing the gasket, be careful not to let broken pieces
of the gasket get inside the engine.
1.
2.
Clean the contact surfaces of every part and corresponding
part with a waste cloth so that they are free of oil, moisture,
and foreign objects.
Apply FlPG to the side of the part to be attached. Parts
requiring FlPG to be applied are listed in the point operations
for each section.
Always overlap the start and finish of the application so that
there is no excess application or insufficient application.
Take care not to move the parts after reassembling them.
Reassemble within
3
minutes of finishing the application.
For at least 2 hours after reassembly, do not pour in coolant or
lubrication oil, and do not start the engine.
To Next Page
Need help?
General
