4.
Fill the engine oil.
(1) Install the oil drain plug using a new gasket.
Caution:
Before installing, dispose of the old gasket that is
adhered to the oil pan and clean the installation surface.
(2) Fill the oil.
Total capacity
(F
level) 7.5
e
(1.98 US gal)
Oil pan capacity 7.0
8
(I .85
US
gal)
(3) Fit the oil filler cap.
5.
Check the oil amount.
Check the amount with the oil level gauge.
6.
Check the oil leakage.
Start the engine and check the system for oil leakage.
7. Check the oil amount.
Recheck the oil amount after the oil leakage check.
Note:
Stop the engine and wait for
3
minutes before
performing the inspection.
OIL STRAINER
REMOVAL AND INSTALLATION
1.
Remove the oil pan. (See P.2-21)
SST 09032-76001 -71
(09032-001 00)
2. Remove the oil strainer.
3. Install the oil strainer.
T
=
14.51 to 21.77 N-m
(148 to 222 kgf-cm) [10.7 to 16.1 ft-lbfl
T
=
10.8 to 15.7 N-m
(110 to 160 kgf-cm) [8.0 to 11.6 ft-lbfl
4.
Install the oil pan. (See P.2-21)
T
=
10.8 to 15.7 N-m
(11 0 to 160 kgf-cm) [8.0 to 11.6 ft-lbfl
To Next Page
Loading...
Need help?
General
