CONVERSION BETWEEN PREVIOUS UNITS AND SI UNITS
Conversion formula
Conversion factor: The figure corresponding
SI unit value =conversion factor
x
previous unit value
to
X
in the conversion
Previous unit value
=
conversion factor
1
SI unit value
value field in the table
above
<Caution>
Make sure that the unit of the previous or
SI unit value used in the calculation is the same as the unit in the
conversion value field in the table above. For example, when converting 100 W into the previous PS unit,
convert it into 0.1
kW before dividing it with the conversion factor of 0.735499.
HANDLING THE FIPG (LIQUID GASKET)
Use 1280B made by THREEBOND or seal packing black for the FIPG.
The part number is set as 08826-76001-71.
Example of coating location description
Coating method and parts reassembly procedure
CAUTION
When removing the gasket, make sure that shreds from
the gasket do not enter the engine.
Clean the connection surface of parts and their
connecting parts with a cloth to eliminate any oil,
moisture or dirt.
Coat the part to be reassembled with FIPG. The parts
that require coating are described in the key point
.
operations in each section.
Do not coat excessively or insufficiently, and be sure to
overlap the beginning and end of the coat.
Do not move the parts after they are reassembled.
Reassemble within
3
minutes of coating the parts.
Do not charge coolant, supply oil or start the engine for
2
hours after the reassembly.
To Next Page
Loading...
Need help?
General
