ÿ at chi"^
mark
w
18. Remove the oil seal.
SST 0961 2-76006-71
(096 12-6501
4)
Note:
Set the SST as shown, and drive out the oil seal with a
driving bar or other appropriate tool.
19. Remove the governor cover parts.
(1) Align the lever shaft with the lever, and draw matching
marks.
(2) Nut
(3) Adjusting lever
(4)
Return spring
(5)
Extract the lever shaft to the inside.
INSPECTION
1. Check the plunger.
(1) When wear, scratches, discoloration or other defects
are found at the plunger lead, replace the plunger,
spill ring and distributor head as a group.
(2) Check the plunger sliding contact surfaces as follows:
Slide the plunger several times in clean light
oil.
Incline the distributor head 60°, and pull out
the plunger by about 15 mm (0.59 in.).
When the plunger is released gently, it must
drop at least
3
mm (0.12 in.) by its own
weight.
Secure the spill ring and distributor head, and
repeat steps (b) and (c) several times, each
time changing the plunger position.
If the plunger does not drop more than 3 mm
by its own weight, replace the plunger, spill
ring and distributor head as a group.
To Next Page
Loading...
Need help?
General
