TP-Link TL-WA5110G User Manual

35
Figure 4-26 Add or Modify an Address Reservation Entry
To modify or delete an existing entry:
1. Select a reserved address entry, Click the Modify in the entry if you want to modify it. If you
want to delete the entry, click the Delete.
2. Click the Save button.
Click the Enable All button to make all entries enabled
Click the Disabled All button to make all entries disabled.
Click the Delete All button to delete all entries.
Click the Next button to go to the next page, or Click the Previous button to return the previous
page.
)
Note:
The change of the address reservation won’t take effect until the device reboot.
4.8 Wireless settings
This page allows you to configure some settings for your wireless network, which is shown in
Figure 4-27.
Figure 4-27 Wireless settings
¾ Enable AP Isolation - Isolate all connected wireless stations so that wireless stations can
not access each other through WLAN. This option is available only for AP mode.

TP-Link TL-WA5110G Specifications

General

2.4 GHz	Yes
Modulation	BPSK, CCK, DBPSK, DQPSK, DSSS, OFDM, QPSK
Frequency band	2.4 - 2.4835 GHz
Cabling technology	10/100Base-T(X)
Receiver sensitivity	54M: -74dBm 48M: -76dBm 36M: -81dBm 12M: -89dBm 11M:-90dBm 9M:-91dBm 5.5M:-92dBm 1M:-94dBm
Maximum data transfer rate	54 Mbit/s
Frequency range	2400 - 2483.5 MHz
Maximum operating distance	50000 m
Compliance industry standards	IEEE 802.11b, IEEE 802.11g
Non-operating relative humidity (non-condensing)	5 - 95 %
Antenna gain level (max)	4 dBi
Internal	No
Certification	CE FCC
Supported network protocols	PPPoE, IP
Ethernet LAN (RJ-45) ports	1
Output power description	12 V
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Dimensions (WxDxH)	165 x 108 x 28 mm