Ubee Interactive Using the LAN IPv6 Option
Ubee DDW36C Advanced Wireless Gateway MSO Operations Guide • October 2015 38
5.4 Using the LAN IPv6 Option
Use the LAN IPv6 option to connect clients with LAN IPv6 addresses.
To configure LAN IPv6 settings:
1. Click Basic from the main menu.
2. Click LAN IPv6 from the left side menu. Field descriptions are listed below the screen
example.
Enable Rapid Commit Enables Rapid Commit. When enabled, the server recognizes
this option in Solicit messages sent from the DHCPv6 client.
The server and client then use a two-message exchange
(Solicit and Reply) to configure clients, rather than the default
four-message exchange (Solicit, Advertise, Request, and
Reply). This provides faster client configuration when networks
are under heavy traffic loads.
Enable Unicast Enables Unicast, which is disabled by default. Unicast
transmission is defined to be between a single sender and a
single user over a network.
Apply Saves changes.
Restore DhcpV6 Defaults Restores default DHCPv6 values.
Label Description
Stateless Auto Configuration
Label Description
To Next Page
Loading...
Need help?
General
