SARA-R5 series - System integration manual
UBX-19041356 - R04 Approvals Page 104 of 118
C1-Public
☞ Check the appropriate applicability of the SARA-R5 series module’s approvals while starting the
certification process of the device integrating the module: the re-use of the u-blox cellular
module’s approval can significantly reduce the cost and time to market of the application device
certification.
The SARA-R5 series modules include the capability to configure the device by selecting the operating
Mobile Network Operator Profile, Radio Access Technology, and bands. In the SARA-R5 series AT
commands manual [2], see the +UMNOPROF, +URAT, and +UBANDMASK AT commands.
As these configuration decisions are made, u-blox reminds manufacturers of the host application
device integrating the SARA-R5 series modules to take care of compliance with all the certification
approvals requirements applicable to the specific integrating device to be deployed in the market.
☞ It is strongly recommended to configure the module to the applicable MNO profile, RAT, and LTE
bands intended for the host end-device and within regulatory compliance.
☞ The certification of the host application device that integrates a SARA-R5 series module and the
compliance of the host application device with all the applicable certification schemes, directives
and standards are the sole responsibility of the host application device manufacturer.
SARA-R5 series modules are certified according to all capabilities and options stated in the Protocol
Implementation Conformance Statement document (PICS) of the module. The PICS, according to the
3GPP TS 36.521-2 [13] and 3GPP TS 36.523-2 [14], is a statement of the implemented and supported
capabilities and options of a device.
☞ The PICS document of the host device integrating SARA-R5 series modules must be updated from
the module PICS statement if any feature stated as supported by the module in its PICS document
is not implemented or disabled in the host application device. For more details regarding the AT
commands settings that affect the PICS, see the SARA-R5 series AT commands manual [2].
☞ Check the specific settings required by the mobile network operators in use by the host application
device, as they may differ from the AT commands factory-programmed settings of the module.
4.2 US Federal Communications Commission notice
United States Federal Communications Commission (FCC) ID: XPYUBX19KM01
4.2.1 Safety warnings review the structure
• Equipment for building-in. Requirements for fire enclosure must be evaluated in the end product
• The clearance and creepage current distances required by the end product must be withheld when
the module is installed
• The cooling of the end product shall not negatively be influenced by the installation of the module
• Excessive sound pressure from earphones and headphones can cause hearing loss
• No natural rubbers, hygroscopic materials, or materials containing asbestos are employed
To Next Page
Loading...
Need help?
General
