49
7.2 PUSH-BUTTON PANEL (TREATING – HEATING)
7.2.1 KEYS (kettle - heating part)
7.2.1.1 key START
7.2.1.1.1 START with the START CYCLE BUTTON on the PUSH-BUTTON PANEL
The START CYCLE button is always set to one of the menu programs
(except when first using the machine).
1. Press the button to display the set NEW
program or the LAST program used.
2. Press START CYCLE again to start the
program (NEW or LAST).
3. Program screen.
All menu programs you can started with the START CYCLE button .
The end of the cycle is notified by a beep and a light signal (if any). A message
is displayed to take out the mixture.
The machine will continue mixing the mixture without heating until extraction,
i.e. until the end of the maximum time limit.
7.2.1.1.2 START with the START CYCLE BUTTON from the MENU
1. Press the button to display the set NEW
program or the LAST program used.
To Next Page
Loading...
Need help?
General
