12. Cleaning and Maintenance
Green Smart User Manual 131
12. Cleaning and Maintenance
The equipment has to be installed and maintained on a flat surface.
12.1 Cleaning
Always turn off the power to the equipment and disconnect it from the
power outlet before cleaning.
Thoroughly clean the areas of the equipment that come in direct contact with the
patient, such as the Chinrest and the Bite.
Do not use spray cleaners or solvents as they could flow into the equipment and
damage the electrical components or cause a fire.
Do not use abrasive liquids such as acetone, gas, or oil, which may cause corrosion
on the surface of the equipment.
Do not use any cleaning products which contain silicon. They could potentially
damage the equipment’s electrical components.
The following table summarizes the standard cleaning procedures to be performed by the
operator.
Components Cleaning Process
Bite
(Normal Bite, Special Bite A,
and Special Bite B)
Clean with ethanol and gently wipe with a dry
towel before the next patient.
Temple Supports
Clean with ethanol and gently wipe with a dry
towel before the next patient.
Chinrest
Clean with ethanol and gently wipe with a dry
towel before the next patient.
Computer and peripherals Follow the manufacturers’ instructions found in the
accompanying manuals.
Outer covers of equipment Wipe the unit with a dry cloth at the end of each
day.
Do not use cleaning agents in aerosol or spray form directly on the
surface of the equipment.
To Next Page
Loading...
Need help?
General
