Changing the helm station
The first time you change control panel after starting
the EVC system, a bulb check is done automatically.
All LEDs and bulbs light up for 2 seconds.
1. Check that the control levers are in neutral on
both the control panel you leave and on the new
control panel.
2. Check that the EVC system is not locked.
3. Press the activation button (1) for at least one sec
-
ond. When the button is released, the indication
lights up to confirm that the control position is acti-
vated.
4. Press the activation button (1) for a further second
to lock the EVC system. The padlock sign lights up
in confirmation. Unlock the system by pressing the
activation button for one second. This can only be
done from an activated control panel.
Synchronizing engine speed
When driving with twin engines, both the operating
economy and comfort will be increased when the en-
gines are operating at the same engine speed (rpm).
When the synchronization function is activated, the
engine speed (rpm) of the starboard engine is auto-
matically adjusted to that of the port engine. The syn-
chronization function is activated automatically if the
following conditions are met.
1. The engine speed levers for both engines are in
(approximately) the same position.
2. The engine speed on both engines must exceed
800 rpm.
NOTE! The synchronizer is disengaged as soon as
the conditions are no longer met.
1
To Next Page
Loading...
Need help?
General
