INSTRUMENTS AND CONTROLS 209
VN 780, VNL 730, VN 670 OFFICE
DANGER
Do not sit at the table when the vehicle is
moving. It is intended for use only when
the vehicle is parked. Passengers should
be in the passenger seat wearing the
safety belt or in the bunk with the bunk
restraint attached. Failure to follow these
instructions may result in severe personal
injury or death in the event of a sudden
stop or accident.
To raise table, remove the cushions from the bunk, place them to the sides.
Line up the latch pegs with the holes in the back wall.
Push the table firmly into the holes. Make sure the latches are caught properly by pulling out
on the table. When the table is in place, put the cushions in place to form a seat and backrest.
To lower the table, remove the cushions and pull the handle underneath the tabletop to
release the latches. Lower the table to its resting position. Place the seat cushions toward the
walls and then position the backrest cushions as illustrated. Press down on the cushions in
the middle to form a mattress. See "VN 780 Bunk Storage" on page189.
To Next Page
Loading...
Need help?
General
