BA DT10 en - Edition 1.5 * dt10b210.fm 2-9
Safety instructions
2.8 Warning of special hazards
Electrical energy
• Use only original fuses with the specified current rating!
Switch off the machine immediately and rectify the malfunction if trouble occurs in the
electrical system!
• During machine operation, maintain a safe distance from overhead electric lines! If
work must be performed close to overhead lines, the equipment/attachments must be
kept well away from them. Caution, danger! Get informed on the prescribed safety
distances!
• If your machine comes into contact with a live wire
• Warn others against approaching and touching the machine
• Have the live wire de-energized
• Do not leave the machine until the line that has been touched or damaged has been
safely de-energized!
• Work on the electrical system may only be performed by a technician with appropriate
training, in accordance with the applicable electrical engineering rules
• Inspect and check the electric equipment of the machine at regular intervals.
Deficiencies such as loose connections or worn cables must be rectified immediately.
• Observe the machine’s operating voltage!
• Always remove the grounding strap from the battery when working on the electrical
system or when performing welding work!
• Starting with battery jumper cables can be hazardous if performed improperly. Observe
the safety instructions regarding the battery!
Gas, dust, steam, smoke
• Operate the machine only on appropriately ventilated premises! Before starting the
internal combustion engine on enclosed premises, ensure that there is sufficient venti-
lation!
Observe the regulations in force at the respective site!
• Welding, burning and grinding work on the machine may only be performed by a
Wacker Neuson dealer. Risk of fire and explosion!
• Before performing welding, flame-cutting and grinding work, clean the machine and its
surroundings from dust and other flammable substances, and ensure that the premises
are appropriately ventilated – explosion hazard!
• In areas with special hazards (for example toxic gases, caustic vapors, toxic environ-
ments), wear appropriate protective equipment (breathing filters, protective clothing)!
Hydraulic
• Work on the hydraulic equipment of the Easy Lock offset bucket must be performed
only by persons having specific technical knowledge and experience in hydraulic
systems!
• Check all lines, hoses and screw connections regularly for leaks and obvious damage!
Repair any damage and leaks immediately. Splashed oil can cause injury and fire
• In accordance with the Operator’s Manual/instructions for the respective assembly,
release the pressure in all system sections and pressure lines (hydraulic system) to be
opened before performing any implementing/repair work!
• Hydraulic and compressed-air lines must be laid and fitted properly. Ensure that no
connections are interchanged. The fittings, lengths and quality of the hoses must
comply with the technical requirements
To Next Page
Loading...
Need help?
General
