Wacker Neuson DT10 User Manual

3-12 BA DT10 en - Edition 1.5 * * dt10b330.fm
Operation
Jump-starting the engine (supply battery)
Safety instructions
• Never jump-start the engine if the battery of the machine is frozen – danger of
explosion!
☞Dispose of a frozen battery!
• The dumper must not touch the jump-starting vehicle when connected with jump leads
– sparking hazard!
• The voltage of the auxiliary power supply must be 12 V; higher supply voltage will
damage the vehicles' electrical system!
• Use only authorized jump leads which conform to the safety requirements and which
are in perfect condition!
• The jump lead connected to the positive + terminal of the starter battery must never be
brought into connection with electrically conductive vehicle parts – danger of short
circuit!
• Route the battery jumper cables so they cannot catch on rotating components in the
engine compartment!
Procedure
☞Drive the jump-starting vehicle close enough to the machine so that the jump leads can
reach to connect the two batteries
☞Let the engine of the jump-starting vehicle run
☞First connect one end of the red jump lead (+) to the + terminal of the flat battery, then
connect the other end to the + terminal of the starting battery
☞Connect one end of the black jumper cable (–) to the – terminal of the starting battery
☞Connect the other end of the black cable (–) onto a solid metal component firmly
screwed on the engine block or onto the engine block itself. Do not connect it to the
negative terminal of the empty battery, as otherwise explosive gas emerging from the
battery can ignite if sparks are formed!
☞Start the engine of the machine with the empty battery
Once the engine has started:
☞With the engine running, disconnect both jump leads in exactly the reverse order (first
remove the
– terminal, then the + terminal) – this prevents sparking near the battery!
Special instructions for driving on public roads
The machine is subject to the:
• Applicable legal regulations of your country (for example road traffic regulations)
Notice!
Operation of electric consumers (for example the lighting equipment) is prohibited.
This is why the vehicle has no socket.
Also observe the applicable regulations for accident prevention of your country.
12 V
12 V
34001b710_05.eps
Fig. 33: Starting aid with battery jumper cables
Empty battery
Starting battery

Wacker Neuson DT10 Specifications

General

Brand	Wacker Neuson
Model	DT10
Category	Construction Equipment
Language	English