wc_tx003863gb_FM10.fm
71
RT / RTx Operation
4.28 Charging the Transmitter Battery
Background
The NiMH battery pack (b) in the transmitter has enough capacity to provide 16
hours of continuous operation. To maintain battery capacity, recharge it during non-
working hours by using the onboard docking port.
Note: There is no need to run the NiMH battery completely down before
recharging. The battery can be recharged from any state of discharge with no loss
in performance or life.
Procedure
To charge the battery, perform one of the following procedures:
■ Plug the transmitter receptacle (a) into the charging port (b). Slide the
transmitter forward until the battery charge light comes on.
■ Plug one end of the control cable into the transmitter receptacle (a) and the
other end into the port (c) on the back of the machine.
To Next Page
Loading...
Need help?
General
