Operating manual Manual Powder System SPRINT XE
6 Assembly and Commissioning
Order number 2354920 | Edition 01/2023 29
6. Connect the powder feed hose.
7. Plug in the gun connection cable on the control unit.
8. Connect the hose (transparent) for the atomizing or Tribo air. Bundle the two hoses and
the gun cable with Velcro cable binders.
9. Connect the compressed air hose (12.5x 18.5mm, order no. 9981951) to the
compressed air connection (G1/4") on the manual system.
10. Connect the trolley grounding cable to the control unit. Connect the control unit's
grounding cable with the signal ground!
11. Plug in the connection cable from the vibrator motor on the control unit. Fasten the
connection cable to the trolley with the delivered Velcro cable binders (A).
12. Plug in the control unit mains cable.
13. Connect mains cable to the power supply.
To Next Page
Loading...
Need help?
General
