Operating manual Manual Powder System SPRINT XE
8 Cleaning and Maintenance
Order number 2354920 | Edition 01/2023 45
After maintenance
4 Carry out safety checks in accordance with Chapter Safety Checks [845].
8.2.3 Safety Checks
8.2.3.1 Grounding Check
Every day
4 Before starting work, carry out a visual check to ensure that the system is grounded.
8.2.4 Maintenance Procedures
The maintenance intervals should be adapted by the operator depending on the level of use
and if necessary the level of soiling.
If in doubt, we recommend contacting WAGNER's specialist personnel.
Maintenance work Time stamp
Per shift Weekly
Blow out gun and check for sintering x
Check gun settings x
Check gun discharge pressure x
Blow out powder hoses x
Check grounding x
Check compressed air quality x
Check gun voltage x
Check powder hoses for bends and sintering x
8.3 PERIODIC CHECKING OF THE MANUAL SYSTEM
8.3.1 Airfluid version
1. Release the trigger lever on the spray gun.
ð The high voltage and the powder feed are deactivated.
2. Lift the feed unit up, underneath the injector, and lift it out of the tank until retaining
clamp (H) swivels downwards.
3. Lower the feed unit into the parking position and swivel it to the right side so that no
more powder is feed.
To Next Page
Loading...
Need help?
General
