Willcox & Gibbs W562 User Manual

LUBRICATION
The oil was drained from the machine when
shipped. So, fill the machine with oil before
starting it for the first time.
1. Lubricating Oil
Use Mobil Velocite oil No. 10 (ISO VG22) or
equivalent.
2. To fill oil
Take out Screw O and pour fresh oil until the
oil level reaches the upper line 'H' of Oil Level
Sight Window ©. Replace Screw O.
3. Oil level
Always keep enough oil in the machine so that
the oil level is between two lines H and L of
Window ©.
4. Manual oiling
Before starting machine for the first time, or
if the machine is idle for more than a couple
of weeks, manually lubricate Needle Bar ©.
5. Oil circulation check
Be sure to check that oil is splashing inside
Window o.
(— Note:
If oil does not splash inside Window 0>
check Oil Filter ®.
6. Oil Change
Change oil after the first I month in operation.
After that, change oil every 6 months.
- Note:
Be sure to change oil because dirty oil can
cause excess wear on moving parts and
shorten the life time of the machine.
7. To drain oil
Take out Screw 0 and drain oil from here.
8. Oil Filter
If Oil Filter 0 is clogged, nomal lubrication
cannot be kept. Check and clean 0 every 6
months at the time of the regular oil change.
^ Note:
If oil jet in Window O is abnormally
restricted or weak, or oil contains bubbles,
check and clean Oil Filter 0 or if necessary,
replace it with new Oil Filter.
- 5 -
From the library of: Superior Sewing Machine & Supply LLC

Willcox & Gibbs W562 Specifications

General

Brand	Willcox & Gibbs
Model	W562
Category	Sewing Machine
Language	English