Commissioning | 5 | English
Operating instructions MT Series | 89014484; Version 1 | 29
5.2.2 Electrical connection
DANGER
Electric shock from live components
A fatal electric shock can occur when the warewasher and its additional devices are connected to the elec-
trical mains supply.
Ø The warewasher and its additional devices may be connected to the electrical mains supply only by a
specialist company registered within the electrical trade and approved by the energy supplier.
Ø All locally applicable standards and regulations must be observed during the connection to the electrical
mains supply.
Ø A protective circuit must be connected properly.
Ø The electrical safety of this warewasher is only guaranteed if it is connected to a correctly installed protective circuit.
Ø The wiring diagram must be observed.
Ø The warewasher may be operated only at the voltages and frequencies specified on the rating plate.
Ø The electrical connection must be secured as a separately fused circuit with slow fuses or circuit breakers. The fuse
protection used depends on the total connected load of the warewasher. The total connected load is specified on the
rating plate of the warewasher.
Ø If a residual current circuit breaker is provided on-site, we recommend installing a Class B all-current sensitive resid-
ual current circuit breaker.
Ø Determine the cable cross-section of the mains cable using the following table:
On-site fuse protection [A] Cable cross-section [mm
2
]
63 16
80 25
100 35
125 50
160 70
200 120
250 150
The mains cable must be an oil-resistant, sheathed and flexible cable. The cable type H07RN-F is recommended.
To Next Page
Loading...
Need help?
General
