Malfunctions | 7 | English
Operating instructions MT Series | 89014484; Version 1 | 39
7.4 Emergency programme (optional)
DANGER
Danger of electric shock due to live components
An electric shock may occur if the cover is removed.
Ø Disconnect the warewasher from the mains supply.
Ø Only qualified electricians are permitted to remove the cover and work on the warewasher with the pan-
elling removed.
If the display fails and the warewasher can no longer be operated, start the warewasher in the emergency programme.
Only the drive, wash pumps and the inlet solenoid valve work in the emergency programme. The water is not heated, the
wash items are rinsed at the temperature of the inlet water and neither rinse aid nor detergent are added.
Ø Note:Running the machine empty of water can dam-
age the wash pumps. If the warewasher tanks are
empty, fill the tanks manually before starting the emer-
gency programme.
Ø Switch off the main switch (5) (horizontal position).
Ø Open the top cover (4) of the last main wash zone.
Ø Switch on the switch (1).
Ø Remove the magnet (3) from its holder.
Ø Replace the cover (4).
Ø Switch on the main switch (5).
Ø Wait until the pumps start up (up to one minute).
Ø To start the transport belt, hold the magnet against the
cover over the reed switch (2).
Ø If the transport belt is stopped (e.g. by opening the
door), restart the transport belt using the magnet.
To Next Page
Loading...
Need help?
General
