5
Wizard CMC Model 8000 RC Hardware and Software Getting Started Manual
CMC 8000RC/Frameshop 20-71034-1 GettingStartedManual8000RCFrameShop
http://info.wizardint.com/KB/default.aspx#pageid=getting_started_manual_8000_rc 04/05/19
Wizard CMC Model 8000 RC Hardware and
Software Getting Started Manual
Check CMC Contents
Upon receipt of equipment, review for shipping damage and advise if any. Verify that contents listed on the pack-
ing slip are received. Read Manual before installing and operating equipment. Save Packaging.
Equipment Required
The CMC Stand must be assembled rst before unpacking the Wizard™ CMC (Computerized Mat Cutter)
1/4" female tting on main airline, or quick disconnect attachment
110 volt electrical outlet
Air source - You will need an air compressor that supplies between 100psi and 120psi.
Surge Protector
Table for the Computer/Monitor
Where to Find More Information
Knowledge Base
Login to the Knowledge Base with your Customer ID, which can be found on your License Screen (Options >
View License from the FrameShop main screen).
The Knowledge Bases contains a wide assortment of searchable documentation and information which can
be found at:
FrameShop Software Knowledge Base: http://info.wizardint.com/FS40.
8000 Hardware can be found on the Knowledge Base: http://info.wizardint.com/KB.
Website
Check out the Wizard website at www.wizardcutters.com for additional information.
To Next Page
Loading...
Need help?
General
