Xerox 4800 Series User Manual

Installation
6 Xerox Scanner User’s Guide
Step 1: Assemble the Scanner
To assemble the scanner:
1. Remove any shipping tape from the top and bottom of the
scanner.
2. (Model 4800TA only) Plug the Transparency Adapter Cable into
the Option port on the body of the scanner.
The Transparency Adapter Cable must be securely attached
for your scanner to be able to scan 35mm slides and negatives.
3. (Model 4800TA only) Open the lid and remove the protective
film from the Transparency Adapter. Discard the protective film.
4. Turn the scanner over and slide the lock tab to the unlocked
position. The scanner must be unlocked for you to continue
with the installation. It must also be unlocked to scan.
5. Proceed to “Step 2: Install the Software.”
NOTE: The locking tab protects the scanner’s scan head by
holding it securely in position. Lock the scanner when
transporting it, but always remember to unlock it before scanning.
The scanner will not scan when locked.
Transparency Adapter Cable

Xerox 4800 Series Specifications

General

Brand	Xerox
Model	4800 Series
Category	Scanner
Language	English