Xerox Scanner User’s Guide 13
Installation
4. Plug the power supply into the scanner power port, then into a
wall outlet.
The status light on the front of the scanner is illuminated,
indicating the scanner is receiving power.
(Models 4800 and 4800TA only) If you are using Windows XP
Service Pack 2, and have plugged the USB cable into a USB
1.1 port, an information bubble may open explaining that “A HI-
SPEED USB device is plugged into a non-HI-SPEED USB
hub”. Plug the USB cable into a USB 2.0 port (if available) or
just disregard the message. If you leave it plugged into the
USB 1.1 port, your scanner may scan a bit slower than if
plugged into a USB 2.0 port.
NOTE: Your scanner does not have a power switch. Plugging it
in turns on the power.
NOTE: Only use the power supply included with your scanner.
Connecting any other type of power supply may damage your
scanner, and will void its warranty.
Status light
To Next Page
Loading...
Need help?
General