Xerox DocuPrint C2200 User Manual

88 5 Control Panel Menus
System Settings
[System Settings] menu is used to make the printer operation settings such as for alarm and
Power Saver mode.
Item Description
Low Power Timer Sets the amount of time before the printer enters the Low Power mode. Specify the
value in 1 minute increments.
• [3 Minutes] to [60 Minutes] (default: [3 Minutes])
Refer to
• "2.4 Setting/Exiting the Power Saver Modes" (P. 39)
• "Setting Example: Changing the Power Saver Mode Setting" (P. 82)
Sleep Mode Consumes less electricity than the Low Power mode. Set whether or not to enable this
feature.
• [Enable] (default)
• [Disable]
Refer to
• "2.4 Setting/Exiting the Power Saver Modes" (P. 39)
Sleep Mode Timer Sets the amount of time before the printer enters the Sleep mode from the Low Power
mode. Specify the value in 1 minute increments.
• [2 Minutes] to [120 Minutes] (default: [2 Minutes])
Note
• When [Sleep Mode] is set to [Disable] (default: [Enable]), the printer does not shift to
the Sleep mode.
Refer to
• "2.4 Setting/Exiting the Power Saver Modes" (P. 39)
Audio Tones Sets the audio tones that indicate various printer conditions such as errors. You cannot
adjust the sound volume.
• [Control Panel] (default: [On])
Sets whether or not to generate an audio tone when the correct button is pressed on
the control panel.
• [Invalid Key] (default: [On])
Sets whether or not to generate an audio tone when the wrong button is pressed on
the control panel, or when an operation is attempted during an error.
• [Machine Ready] (default: [On])
Sets whether or not to generate an audio tone to inform you that the printer is ready
to print (such as right after powering on).
• [Job Completed] (default: [On])
Sets whether or not to generate an audio tone when a job finishes successfully.
• [Fault Tone] (default: [On])
Sets whether or not to generate an audio tone when a job finishes abnormally.
• [Alert Tone] (default: [On])
Sets whether or not to generate an audio tone when a fault (such as a paper jam)
occurs and a job is held in a fault state.
• [Out of Paper] (default: [On])
Sets whether or not to generate an audio tone when the printer runs out of paper and
a job is held in a fault state.
• [Low Toner Alert] (default: [On])
Sets whether or not to generate an audio tone when a print cartridge needs to be
replaced.
• [Base Tone] (default: [On])
Sets whether or not to generate an audio tone when a button, which toggles between
different options when pressed repeatedly, is pressed.
Fault Time-out Sets the amount of time the printer waits for displaying an error. If a time-out occurs
during error status, it restores the printer from the error.
• [3 Seconds] to [300 Seconds] (default: [60 Seconds])
Specify the time-out value in 1 second increments.
•[Off]
Disables the fault time-out.

Xerox DocuPrint C2200 Specifications

General

Brand	Xerox
Model	DocuPrint C2200
Category	Printer
Language	English