8-4 Phaser 3600 Printer Service Manual
Parts List
Using the Parts List
1. No.: The callout number from the exploded part diagram.
2. Part Number: The material part number used to order specific parts.
3. Qty: This number represents the parts per printer, not the number of
parts supplied in the actual part order.
4. Name/Description: Details the name of the part to be ordered and the
number of parts supplied per order.
5. Parts identified throughout this manual are referenced PL #.#.#; For
example, PL 3.1.10 means the part is item 10 of Parts List 3.1.
6. A black triangle preceding a number followed by a parenthetical statement
in an illustrated parts list means the item is a parent assembly, made up of
the individual parts called out in parentheses.
7. The notation “with X~Y” following a part name indicates an assembly that
is made up of components X through Y. For example, “1 (with 2~4)”
means part 1 consists of part 2, part 3, and part 4.
8. An asterisk (*) following a part name indicates the page contains a note
about this part.
9. The notation (NS) next to a part indicates that particular part is not
spared, but contained in a kit or major assembly.
The notation “J1<>J2 and P2” is attached to a wire harness. It indicates that
conne
ctor Jack 1 is attached to one end of the wire harness and connector J2
is attached to the other end that is plugged into P2.
Only parts showing part numbers are available for support. Parts not
sho
wing part numbers are available on the parent assembly.
Identifier Meaning
C C-ring
E E-ring
KL K-clip
S Screw