2-10 Phaser 3600 Printer Service Manual
Theory of Operation
Printer Controls
Paper Size Control
The paper size selection for Tray 2 and Tray 3 is set by moving the paper
guide in the tray. This in turn sets the plastic “fingers” on the side of the paper
tray to a specific postion.The position of the “fingers” activates the correct
combination of the three paper size switches, located in each paper tray slot,
for the selected paper size. Additionally, the back of the tray must be pulled
down in order to select the two largest sizes; US Folio and Legal. Not all sizes
can be used in both trays. See “Media and Tray Specifications” on page 10 for
a complete listing of the media types for each tray. Additional media types can
be
us
ed in Tray 1 (MPT). After inserting the media in Tray 1, use the Control
Panel controls to select the media type.
Automatic Paper Pick Control
The default paper pick selection at power ON is Tray 2, Auto-Select ON is also
default. If the default tray is empty, the printer will automatically switch to any
other tray that contains paper unless Auto-Select is set to OFF.
Paper Size
Paper Size Switch
SW1 SW2 SW3
LEGAL 14" ON ON OFF
US FOLIO (LEGAL 13”) OFF OFF OFF
A4 OFF ON ON
LETTER ON OFF OFF
EXECUTIVE OFF ON OFF
B5 ON OFF OFF
B5, JIS-B5 OFF OFF ON
A5 ON ON ON
No Tray OFF OFF OFF