10
LO
N
G
ER
SHORTER
904306
SFH M3x6
902310
SH M3x10
2.8 mm
Use rear MIDDLE hole
FRONT TRANSMISSION
901408
SB M4x8
1. Press the #302551 eccentric servo saver plastic
holder into the corresponding hole in the chassis.
The tab goes to the REAR.
2. Press the #930407 (BB 4x7) ball-bearing into
the plastic holder in the chassis.
3. Mount the right front bulkhead to the lower
chassis using three #904306 (SFH M3x6) screws.
4. Place the front Multi-Diff™ or ball differential
inside the front end of the long front drive belt.
Orient the front Multi-Diff™ or ball differential so
the LONG output shaft points toward the RIGHT
front bulkhead, then slide the output shaft through
the ball-bearing.
5. Slide the left front bulkhead into position over
the other end of the front Multi-Diff™ or ball
differential, and mount to the lower chassis using
three #904306 (SFH M3x6) screws.
BOTTOM
TOP
FRONT
1. Mount lower suspension holders to the outside rear of the front bulkheads,
using a #902310 (SH M3x10) screw and #302032 alu nut.
Use the rear MIDDLE holes as shown.
2. For each front lower arm, slide a #307214 pivot pin through
the holes in the arm, and into the holes in the rear
lower holders.
3. For each front lower arm, mount a
front lower holder onto the front of the
pivot pin. Attach the front lower holders
to the outside front of the bulkheads
using a #902310 (SH M3x10) screw
and #302032 alu nut. Use the
MIDDLE holes as shown.
901308
SB M3x8
930407
BB 4x7
DETAIL
3.0 mm
The left and right front lower arms are mirror images.
1. Thread a #901408 (SB M4x8) downstop adjustment screw into the
innermost hole at the rear of each front lower arm, closest to the pivot pin
holes. The screw must protrude 2.8 mm below the arm.
2. Thread one #901308 (SB M3x8) setscrew into the hole at the front of the
arm as shown. The setscrew must protrude 3.0 mm.
DETAIL
FRONT
TAB TO REAR
REAR
Use front MIDDLE hole
To Next Page
Loading...
Need help?
General
