Assemble the servo link by threading #302662 ball joints onto the ends of a #302615 turnbuckle.
The ball joints should be perpendicular (90°) to each other.
Adjust to the proper length as shown.
Note: The turnbuckle has a CCW thread on one end and a CW thread on the other end.
6. STEERING
FACTORY PRE-ASSEMBLED
approx. 53 mm
302502
62 mm
30 2502 CENTRAL SERVO SAVER T1FK'05 (SET)
30 2551 SERVO SAVER PLASTIC COVER - ECCENTRIC (2)
30 2580 COMPOSITE SERVO HORN - KO, JR, AIRTRONICS, MULTIPLEX
30 2582 COMPOSITE SERVO HORN - FUTABA, ROBE
30 2611 ADJ. STEERING ROD L/R 35 MM - SPRING STEEL (2)
30 2615 ADJ. STEERING ROD 30 MM - SPRING STEEL (2)
30 2662 BALL JOINT 5 MM - OPEN (6)
30 6510 ALU TOP DECK MOUNT (2)
30 7454 PIVOT BALL 5.0 MM DOUBLE BEVEL SHOULDERS (10)
90 2310 HEX SCREW SH M3x10 (10)
90 2312 HEX SCREW SH M3x12 (10)
90 4306 HEX SCREW SFH M3x6 - SILVER (10)
93 0407 BALL-BEARING MR74ZZ 4x7x2.5 (2)
30 1164 UPPER DECK T1FK'05 - CNC MACHINED
90 4306 HEX SCREW SFH M3x6 - SILVER (10)
1:1
Assemble the right and left steering rods by threading #302662 ball joints onto the ends of #302611 turnbuckles. The ball joints
should be parallel with each other. Adjust to the proper lengths as shown.
Note: Each turnbuckle has a CCW thread on one end and a CW thread on the other end.
1:1
BAG
06
To Next Page
Loading...
Need help?
General
