Attach TWO rear shocks by performing the following steps.
1. Mount the top pivot ball of the assembled rear shock to
the rear shock tower using #902306 (SH M3x6) screw.
Use the indicated hole as shown.
2. Thread the lower pivot ball of the assembled rear shock
onto the protruding screw at the back of the rear lower arm.
30 1230 COMPOSITE BUMPER REAR
30 1330 REAR BODY MOUNT SET
90 2306 HEX SCREW SH M3x6 (10)
90 2308 HEX SCREW SH M3x8 (10)
90 4308 HEX SCREW SFH M3x8 - SILVER (10)
96 0030 NUT M3 (10)
98 1210 PIN 2x10 (10)
30 8300 XRAY SHOCK ABSORBER-SET 4-STEP (2)
Assemble TWO rear body posts by performing the following
steps.
1. Mount the body post to the front of the rear shock tower. The
bottom plastic pin fits into the lower hole. Use a #902308 (SH
M3x8) screw to fasten each body post to the shock tower.
2. Insert a #981210 (P 2x10) pin into one of the holes in the
rear body post. Insert the other pin into the same hole in the
other body post.
3. Glue a rubber washer to the top of a plastic body support.
4. Slide the body support onto the body post, and snap onto the
pin.
8. REAR ASSEMBLY
902308
SH M3x8
981210
P 2x10
CA GLUE
REAR LOWER ARM REAR SHOCK TOWER
INITIAL POSITION
Attach #301230 rear bumper to back edge of chassis
using #904308 (SFH M3x8) screw and #960030
(N M3) nut.
902306
SH M3x6
904308
SFH M3x8
960030
N M3
REAR SHOCK
(Yellow spring)
BAG
08
To Next Page
Loading...
Need help?
General
