=== Selection Changed ===
Press [ENTER] to CONFIRM
Switching from Analogue to AES Sources
To select inputs, from the home screen, press MENU, choose the CONFIGURATION Sub-Menu
and press ENTER.
Use the encoder or BACK and NEXT keys to find the Input AES Selection option and press
ENTER.
The screen will now show the current choice for the physical XLR inputs on channels C&D:
Use the encoder or BACK and NEXT keys to cycle between the four combinations, of analogue
(Ana) or Digital (AES). Press ENTER to confirm the choice, and again to confirm if changes
have been made.
If a digital source is chosen for either XLR, the AES IN LED on the front panel will begin to
flash until a valid lock is seen for the selected inputs.
If the AES input(s) have valid stable signals and
there are no other issues, the LED will not be
flashing.
Note that the AES LED being illuminated
does NOT mean that an AES source is being
used or routed anywhere within the
amplifier. It is an indication that valid AES
is connected.
To Next Page
Loading...
Need help?
General
