To Next Page

To Previous Page

Filter Function Display

Displays the passband status of the DSP lter. The operation of WIDTH, SHIFT, NOTCH, CONTOUR etc.

can be observed.

State of CONTOURState of NOTCH

Passband status of DSP filter

(SHIFT, WIDTH)

The current roong lter bandwidth is displayed as a blue line below the lter function display.

SSB Mode CW Mode RTTY Mode PSK/DATA Mode

DSP filter bandwidth

Roofing filter bandwidth

Touch the lter display to reveal and check the setting value of the last used function from SHIFT, WIDTH, NOTCH,

CONTOUR, and APF. The setting may be changed by turning the knob of the active function.

Example: When the last function used is the NOTCH function

Touch the lter display to display the NOTCH function setting value.

• Select the roong lter

Touch [R.FIL] in to display the roong lter selection screen on the display. Touch the bandwidth of the

desired lter to select it.

Selectable filters (bandwidth)

• Turn the spectrum display OFF

To display only the DSP lter bandwidth information, press and hold the spectrum area of the lter func-

tion display to clear the spectrum view. To display it, press and hold again.

Yaesu FTDX10 User Manual

Other manuals for Yaesu FTDX10