VX-6R/E OPERATING MANUAL 9
INSTALLATION OF FNB-80LI BATTERY PACK
The FNB-80LI is a high-performance Lithium-Ion battery providing high capacity in a very
compact package. Under normal use, the FNB-80LI may be used for approximately 300
charge cycles, after which operating time may be expected to decrease. If you have an old
battery pack which is displaying capacity which has become diminished, you should re-
place the pack with a new one.
Install the FNB-80LI as shown in the illustration.
Close the Battery Pack Latch on the bottom of the radio.
INSTALLATION OF ACCESSORIES
1) Do not attempt to open any of the rechargeable Li-Ion packs, as personal
injury or damage to the Li-Ion pack could occur if a cell or cells become acci-
dentally short-circuited.
2) Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
BATTERY CHARGING
If the battery has never been used, or its charge is depleted, it may be charged by connect-
ing the NC-72/PA-48 Battery Charger to the EXT DC jack. If only 12 ~ 16 Volt DC power is
available, the optional E-DC-5B or E-DC-6 DC Adapter (with its cigarette lighter plug) may
also be used for charging the battery.
The display will indicate “CHGING,” and the TX/BUSY indicator will glow red, while the
battery is being charged. When charging is finished, the display will change to indicate
“CHGFUL” and the TX/BUSY indicator will glow green.
The NC-72/PA-48 is designed only for charging the battery. The NC-72/PA-48 is
not designed to power the transceiver for reception or transmission operation.
To Next Page
Loading...
Need help?
General
