VX-6R/E OPERATING MANUAL 87
SET
(
MENU
)
M
ODE
The VX-6R/E Set Mode, already described in parts of many previous chapters, is easy to
activate and set. It may be used for configuration of a wide variety of transceiver param-
eters, some of which have not been detailed previously. Use the following procedure to
activate the Set Mode:
1. Press the
[
F/W
]
key, then press the
[
0
(
SET
)]
key to enter the Set mode.
2. Rotate the DIAL knob to select the Set Mode Item to be ad-
justed.
3. Press the
[
0
(
SET
)]
key momentarily to enable adjustment of the
Set Mode Item.
4. Rotate the DIAL knob to adjust or select the parameter to be
changed on the Set Mode Item selected in above step.
5. After completing your selection and adjustment, press the PTT switch momentarily to
save the new setting and exit to normal operation.
Some Set Mode Items (like Set Mode Item 50: TN FRQ) require that the
[
0(SET)
]
key be pressed after setting of the parameter, and before exiting to
normal operation.
“MY MENU” Short-cut Key Setup
In the factory default, the primary (press key) function of the
[ (
LK
)
TXPO
]
key is set to
activating the Internet Connection feature. However, you may change the primary (press
key) function of the
[ (
LK
)
TXPO
]
key to a short-cut path for recall of one of Set Mode
Items.
1. Press and hold in the
[ (
LK
)
TXPO
]
key while turning the radio on. This procedure
switches the
[ (
LK
)
TXPO
]
key between the “Internet Connection” function and the
“MY MENU” key function.
2. Recall the Set Mode Item which you wish to assign to the
[ (
LK
)
TXPO
]
key as a
Menu short-cut.
3. Press and hold in the
[ (
LK
)
TXPO
]
key for one second to assign the Set Mode Item
to the
[ (
LK
)
TXPO
]
key. “MY KEY” will appear on the display, to confirm that the
command was executed.
4. Now, a momentary press of the
[ (
LK
)
TXPO
]
key will immediately recall the se-
lected Menu item. You must press the
[ (
LK
)
TXPO
]
key again to exit to normal
operation.
To Next Page
Loading...
Need help?
General
