Yamaha 40 User Manual

EMD00011
STEERING FRICTION ADJUSTING
SCREW(for Tiller control model)
A friction device provides resistance to
steering movement. This is adjustable for
operator preference. An adjusting
screw/bolt is located on the swivel bracket.
EMD00310*
Adjustment
w
Do not overtighten the friction screw/bolt.
If there is too much resistance, it may be
difficult to steer, which could result in an
accident.
2-12
GB
EMC42210
CHOKE KNOB
Manual start model
Pulling out this knob (setting it to ON)
supplies a rich mixture required to start
the engine.
305043*
209015
408015
Resistance Screw/bolt
Increase Turn clockwise
Decrease Turn counterclockwise
EMC44010
RECOIL STARTER HANDLE
(If equipped)
Pull the handle gently until resistance is
felt. Then vigorously pull the handle
straight out to crank the engine to start it.
63B-9-78-A0-2 2/17/03 4:26 PM Page 26

Yamaha 40 Specifications

General

Full Throttle RPM Range	5000 - 6000 rpm
Fuel Induction System	EFI (Electronic Fuel Injection)
Starting System	Electric
Displacement	747cc
Prop Shaft Horsepower	40hp
Ignition System	TCI