Yamaha 5C User Manual

GB
4-4
EMU01369*
TRANSPORTING AND
STORING OUTBOARD MOTOR
w
Leaking fuel is a fire hazard. When trans-
porting and storing the outboard motor,
close the air vent screw and fuel cock to
prevent fuel from leaking.
TRAILERING OUTBOARD MOTOR
The motor should be trailered and stored
in the normal running position. If there is
insufficient road clearance in this position,
then trailer the motor in the tilt position
using a motor support device such as a
transom saver bar.
cC
Do not use the tilt support lever/knob
when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the motor can not be
trailered in the down position, use an
additional support device to secure it in
the up position.
6A1-9-7LA0-4B 3/7/02 12:17 PM Page 118

Yamaha 5C Specifications

General

Fuel Induction System	Carburetor
Starting System	Manual
Ignition System	CDI
Gear Ratio	2.08 : 1
Propeller Shaft Horsepower	5 hp
Full Throttle RPM Range	4500 - 5500 rpm
Gear Shift	Forward, Neutral
Cooling	Water