234
Chapter 6 RECORDING Mode
SETUP Function
SETUP - Trigger
Selects the trigger types used to start and stop recording.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select Trigger.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔ --
Push action ✔ ----
You use this page to set the type of triggers used to start and stop actual recording.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the SETUP function. Available
pages are: RecData, Target, KeyRnge, Trigger (this page), and Process.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 StartBy = ManOnly, SrcIn
Turn the knob to set the type of trigger used to start recording. The setting determines
how the A3000 switches from standby into actual recording.
ManOnly Manual trigger only. The A3000 does not begin recording until
you push Knob 4 (>START) at the recording standby page (☞224)
SrcIn The A3000 automatically begins recording when the input level
rises above the SrcIn level specified in the METER function’s
TrgLvl page (☞237). But you are free to start recording earlier
than this by pushing Knob 4 (>START) at the standby page.
Knob 3 StopBy = ManOnly, SrcOut
Turn the knob to set the type of trigger used to stop recording.
ManOnly Manual trigger only. The A3000 stops recording only when you
push Knob 5 (>FINISH) or Knob 2 (>STOP), or when you run
out of free memory.
SrcOut The A3000 automatically stops recording when the input level
falls below the SrcOut level specified in the METER function’s
TrgLvl page (☞237). But you are free to stop recording earlier
than this by pushing Knob 5 (>FINISH) or Knob 2 (>STOP).
To Next Page
Need help?
General
