COMMAND Pages
281
Chapter 8 UTILITY Mode
Chapter 8
COMMAND Pages
This section describes the command screens (command pages) that you can access by pressing
the COMMAND key while working in UTILITY mode.
SAVE
Saves object(s) from memory to disk.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Press the COMMAND key, then turn Knob 1 to select >SAVE.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔ ----
Use this page to save the selected memory-resident object(s) to disk.
Knob 1 Change Page >SAVE
• Turn the knob to change to a different command page.
• Push the knob when you are ready to execute the save. The A3000 returns a confir-
mation prompt. Push Knob 5 (>YES) to proceed with the save, or Knob 4 (>NO) to
cancel.
• If a name conflict occurs (if the selected object in main memory has the same name
as a corresponding object on the target volume), the A3000 prompts for instructions
about how to resolve the conflict. (☞100)
Knob 2 Type of Save = All(wipe), AllPgm(wp), Edited, AllSmp, Seq
Turn the knob to select the object(s) to be saved to disk. Selections are as follows.
All(wipe) Saves all memory content to disk. This operation saves all ob-
jects currently in memory (all usable programs, all samples, and
all sequences) to the destination volume on disk. The operation
erases all data already existing in the destination disk volume.
[Note: a program is usable if it uses at least one sample or if its
“AD In” setting is on.]
To Next Page
Loading...
Need help?
General
