Starting Out
38
Chapter 2 Trying It Out
Starting Out
This section guides you through the easiest procedure for recording and replaying a sample.
Recording
We begin with a short vocal recording — a 2-second, continuous ahhhh sound— that
you will record through a microphone. In subsequent sections you will record other
vocal samples, and then learn how to edit the samples and put them together.
Procedure
1.
Switch on power to the A3000 and connected devices. Be sure to switch on
your devices in the correct sequence.
For information about the appropriate power-on sequence, refer to Chapter 1. (☞30)
▼The screen should now look like this.
2.
Select REC mode, SETUP function.
Press the RECORDING mode button (REC button), and then press the second function
key.
▼The RecData page appears.(The name “RecData” appears at the lower left of the screen.)
If the above page does not appear, try turning Knob 1 as necessary to produce it.
Memo
• Each operation is identified by its mode and function. You begin the operation by pressing the
appropriate mode button (along the left), followed by the function key (along the top), so that the
corresponding screen (or page) appears. Note that you do not need to press the mode button if the
mode is already selected — the mode remains effective until you change it.
• Most screens include a descriptive screen name at the lower left corner.
PLAY
EDIT
REC
DISK
UTILITY
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
To Next Page
Loading...
Need help?
General
