E
4-18
000311
EMU00381
CHECKING TIMING BELT
Inspect the timing-belt and replace it if
any of the following signs is observed:
8 Cracks in the back of the belt or in the
base of belt teeth.
8 Excessive wear at the roots of cogs.
8 Rubber portion swollen by oil.
8 Belt surfaces roughened.
8 Signs of wear on edges or outer surface
of belt.
cC
Consult your Yamaha dealer when replac-
ing or adjusting the timing-belt.
NOTE:
If the timing belt can be stretched by 10
mm (0.39 in) or more by pushing with
your finger in the middle between the pul-
leys, the belt tension needs adjust.
6) Turn off the engine and wait 3 min-
utes. Recheck the oil level using the
dipstick to be sure the level falls
between the upper and lower marks.
Fill with oil if it is below the lower
mark, or drain to the specified level if
it is above the upper mark.
7) Dispose of used oil according to local
regulations.
NOTE:
8 For disposal of used oil consult your
Yamaha dealer.
8 The oil should be changed more often
when the engine is operated under
adverse conditions such as extended
trolling.
68V-9-13-4 3/15/02 1:59 PM Page 19
To Next Page
Loading...
Need help?
General
