Operation
74
3. Set the tilt support lever to support the
engine. WARNING! After tilting the
outboard motor, be sure to support it
with the tilt support knob or tilt sup-
port lever. Otherwise the outboard
motor could fall back down suddenly
if oil in the power trim and tilt unit or
in the power tilt unit loses pressure.
[EWM00263]
NOTICE: Do not use the tilt
support lever or knob when trailering
the boat. The outboard motor could
shake loose from the tilt support and
fall. If the motor cannot be trailered in
the normal running position, use an
additional support device to secure it
in the tilt position. For more detailed
information, see page 77.
[ECM01642]
4. Once the outboard motor is supported
with the tilt support lever, press the pow-
er trim and tilt switch “ ” (down) to re-
tract the trim rods. NOTICE: Make sure
that the trim rods retracts completely
during mooring. This protects the
rods from marine growth and corro-
sion, which could damage the power
trim and tilt mechanism.
[ECM00253]
EMU35517
Procedure for tilting down (power
trim and tilt models)
1. Push the power trim and tilt switch “ ”
(up) until the outboard motor is support-
ed by the tilt rod and the tilt support lever
becomes free.
2. Release the tilt support lever.
6CE-9-36-1E0.book 74 ページ ２０１４年１１月２８日 金曜日 午後２時５５分
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
Need help?
General
