Operation
76
2. Slightly tilt the outboard motor up to the
desired position using the power trim
and tilt switch. WARNING! Using the
power trim and tilt switch on the bot-
tom cowling while the boat is moving
or engine is on could increase the
risk of falling overboard and could
distract the operator, increasing the
risk of collision with another boat or
an obstacle.
[EWM01851]
3. To return the outboard motor to the nor-
mal running position, press the power
trim and tilt switch and slowly tilt the out-
board motor down.
EMU41371
Operating in other conditions
Operating in salt water
After operating in saltwater, brackish water,
or water high in other minerals, flush the
cooling system with fresh water to minimize
corrosion and clogging of the cooling water
passages with deposits. Also, rinse the exte-
rior of the outboard motor with fresh water.
Operating in water containing mud, sand,
silt, debris, or vegetation
Mud, sand, silt, debris, and vegetation in the
water may restrict water flow into the cooling
water inlet covers or clog internal water pas-
sages. Check and clean the cooling water in-
let covers frequently when operating in these
conditions. Flush the engine with clean, fresh
water after use in these environments. Con-
sult your dealer if normal water flow can not
be restored by cleaning the cooling water in-
let covers or flushing with fresh water.
6CE-9-36-1E0.book 76 ページ ２０１４年１１月２８日 金曜日 午後２時５５分
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
