Operation
27
EMU27130
Controls
● Check throttle, shift, and steering for proper
operation before starting the engine.
● The controls should work smoothly, without
binding or unusual free play.
● Look for loose or damaged connections.
● Check operation of the starter and stop
switches when the outboard motor is in the
water.
EMU27140
Engine
● Check the engine and engine mounting.
● Look for loose or damaged fasteners.
● Check the propeller for damage.
EMU27163
Checking the engine oil level
1. Put the outboard motor in an upright po-
sition (not tilted).
2. Remove oil dipstick and wipe it clean.
3. Completely insert the dipstick and re-
move it again.
4. Check the oil level using the dipstick to be
sure the level falls between the upper and
lower marks. Fill with oil if it is below the
lower mark, or drain to the specified level
if it is above the upper mark.
NOTE:
Be sure to completely insert the dipstick into
the dipstick guide.
EMU27433
Filling fuel
WARNING
EWM00060
Gasoline and its vapors are highly flam-
mable and explosive. Keep away from
sparks, cigarettes, flames, or other sourc-
es of ignition.
1. Remove the fuel tank cap.
2. Carefully fill the fuel tank.
3. Securely close the cap after filling the
tank. Wipe up any spilled fuel.
1. Lower level mark
2. Oil dipstick
3. Upper level mark
ZMU02082
1
3
2
Fuel tank capacity:
12.0 L (3.17 US gal) (2.64 Imp.gal)
ZMU04484
U60R13E0.book Page 27 Thursday, April 6, 2006 10:29 AM
To Next Page
Loading...
Need help?
General
