Operation
46
2. Slightly tilt the outboard motor up to the
desired position using the power trim and
tilt switch / power tilt switch.
3. To return the outboard motor to the nor-
mal running position, press the power
trim and tilt switch / power tilt switch and
slowly tilt the outboard motor down.
EMU28192
Cruising in other conditions
Cruising in salt water
After operating in salt water, flush the cooling
water passages with fresh water to prevent
them from becoming clogged with salt depos-
its.
NOTE:
For cooling system flushing instructions, see
page 49.
Cruising in turbid water
Yamaha strongly recommends that you use
the optional chromium-plated water pump kit
(not available for some models) if you use the
outboard motor in turbid or muddy water con-
ditions.
UP
ZMU01935
UP
DN
U60R13E0.book Page 46 Thursday, April 6, 2006 10:29 AM
To Next Page
Loading...
Need help?
General
