Operation
41
CAUTION:
ECM00241
● Before tilting the outboard motor, stop
the engine by following the procedure
on page 36. Never tilt the outboard mo-
tor while the engine is running. Severe
damage from overheating can result.
● Do not tilt up the engine by pushing the
tiller handle (if equipped) because this
could break the handle.
EMU27978
Procedure for tilting up (manual tilt
models)
1. Place the gear shift lever in neutral.
2. Disconnect the fuel line from the out-
board motor.
3. Place the tilt lock lever (if equipped) in the
release/up position.
4. Pull up the shallow water lever (if
equipped).
5. Hold the rear of the top cowling with one
hand and tilt the engine up fully.
6. Push the tilt support knob into the clamp
bracket. Or the tilt support bar will turn to
the lock position automatically.
EMU28006
Procedure for tilting up
Power trim and tilt models / power tilt models
1. Place the remote control lever / gear shift
lever in neutral.
N
ZMU03196
U60R13E0.book Page 41 Thursday, April 6, 2006 10:29 AM
To Next Page
Loading...
Need help?
General
