ZIEHL-ABEGG AM-CAN-OPEN User Manual

8.3.3 General
MB Holding Register1, Address: h0 = PIN input
MB Holding Register1, Address: h0 PIN input
Code input to execute special functions e.g. default setting
Access / necessary PIN protection level RW /
| 0 |
minimal value 0
maximum value 65535
Default 0
Bit [15:0] Decimal value 0 - 65535
PIN Code Function
3698
Communications parameters take-over
2143
Reset motor controller (approx. 3.2 sec delay)
1234
Release of the PIN protection level
| 1 | , at programmed PIN
protection level
| 0 | ( register address: 16 / bits [9:8])
0010
Release of the PIN protection level
| 2 | , at programmed PIN
protection level
| 0 | and | 1 | ( register address: 16 / bits [9:8])
7401
Reset current maximum value memory
7500 - 7509
Selection events memory 0 up to 9 (content of events memory
place is copied in query i30, i31 register). 7500 is the most
current fault
xxxx
Administrator password (factory configuration)
xxxx
Delete error memory
xxxx
Loading the factory settings:
xxxx
COM Watchdog Reset
xxxx
Code on request from ZIEHL-ABEGG
Information
•
Without any further action a released PIN protection level is reset automatically to the programmed
PIN protection leval after approximately 15 minutes!
•
Reset to factory setting is possible only by parameter set download. Each device has a set of
parameters. This is loaded by the factory and can be loaded any time with ZIEHL-ABEGG tools
again.
Operating Instructions AM-CAN-OPEN – model series Enclosure
L-BAL-E199-GB 1846 Index 005 Part.-No. 00163405-GB
24/28

ZIEHL-ABEGG AM-CAN-OPEN Specifications

General

Brand	ZIEHL-ABEGG
Model	AM-CAN-OPEN
Category	Control Unit
Language	English