SJ-20200714160642-002 | 2020-07-27(R1.0)
ZXHN H2640 Maintenance Management Guide(TIM)
This procedure describes how to configure basic parameters of the VoIP service,
including sip account, authorization username, password.
1.
On the main page of the ZXHN H2640, select VoIP > Basic. The SIP Account-1
page is displayed, see Figure 6-2.
Figure 6-2 SIP Account-1 Page
2.
Set the parameters. For a description of the parameters, refer to Table 6-1.
Table 6-1 Parameter Descriptions for the SIP Account-1
Specifies whether to enable the VoIP service.
Registered name of a SIP subscriber. Normally, it is the phone number of the
subscriber.
Username for authentication by the SS system, which must be the same as
that configured in the SS system.
Password for VoIP service authentication by the SS system, which must be
the same as that configured in the SS system.
3.
Click Apply button to apply the changes.
Note
SIP Account-2 configuration refers to SIP Account-1 configuration.
To Next Page
Loading...
Need help?
General
